Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
Publications / Theses
- 2016
- Published
An evaluation of the reproducibility of ultrasonic sensor-based out-of-plane permeability measurements: a benchmarking study
Becker, D., Grössing, H., Konstantopoulos, S., Fauster, E., Mitschang, P. & Schledjewski, R., 1 Jun 2016, In: Advanced Manufacturing: Polymer and Composites Science. 2, 1Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of textile parameters on the in-plane permeability characteristics of non-crimped fabric preforms
Grössing, H., Fauster, E., Weninger, M. & Schledjewski, R., 1 Jun 2016, In: Polymer Composites. 37, 6, p. 1854-1863 10 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Review of cost estimation: methods and models for aerospace composite manufacturing
Hueber, C., Horejsi, K. & Schledjewski, R., 1 Jun 2016, In: Advanced Manufacturing: Polymer and Composites Science. Vol. 2Research output: Contribution to journal › Article › Research › peer-review
- Published
BOTTOM-UP PARAMETRIC HYBRID COST ESTIMATION FOR COMPOSITE AEROSPACE PRODUCTION
Hueber, C., Horejsi, K. & Schledjewski, R., Jun 2016, Proceeding of the 17th European Conference on Composite Materials. Munich/ GermanyResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Green Composites: Challenges to reach high performance components
Lloret Pertegas, S., Anusic, A., Resch-Fauster, K. & Schledjewski, R., Jun 2016.Research output: Contribution to conference › Paper
- Published
Green Composites: Challenges to reach high performance components
Lloret Pertegas, S., Jun 2016.Research output: Contribution to conference › Poster › Research
- Published
Models to Predict the Viscosity of Metal Injection Molding Feedstock Materials as Function of Their Formulation
Gonzalez-Gutierrez, J., Duretek, I., Kukla, C., Poljšak, A., Bek, M., Emri, I. & Holzer, C., 28 May 2016, In: Metals : open access journal . 6, 6, p. 129- 146 17 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Instrumented injection mold for the measurement of demolding energies of micro-structured parts
Holzer, C., 20 May 2016.Research output: Contribution to conference › Presentation › Research
- Published
Rheometry of Polymer Melt using Processing Machines
Friesenbichler, W., Neunhäuserer, A. & Duretek, I., 19 May 2016, p. 2-5. 4 p.Research output: Contribution to conference › Presentation › Research › peer-review
- Published
Entwicklung von Polyolefinen für den Fused Filament Fabrication (FFF) Prozess
Spörk, M., Schuschnigg, S. & Holzer, C., 14 May 2016.Research output: Contribution to conference › Poster › Research
