Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
921 - 930 out of 3,454Page size: 10
Publications / Theses
- 2016
- Published
Simulation of the Influence of Thermal Properties of the Mould Steel on the Injection Moulding Process
Holzer, C., Lucyshyn, T. & Des Enffans D'Avernas, L-V., 27 Jul 2016.Research output: Contribution to conference › Presentation › Research
- Published
Effect of Particle Size on the Properties of Highly-Filled Polymers for Fused Filament Fabrication
Kukla, C., Duretek, I., Schuschnigg, S., Gonzalez-Gutierrez, J. & Holzer, C., 25 Jul 2016, p. 299. 1 p.Research output: Contribution to conference › Abstract
- Published
Effect of Particle Size on the Properties of Highly-Filled Polymers for Fused Filament Fabrication
Kukla, C., Duretek, I., Schuschnigg, S., Gonzalez-Gutierrez, J. & Holzer, C., 25 Jul 2016, 32nd International Conference of the POLYMER PROCESSING SOCIETY. Maazouz, A. (ed.). Lyon, France, Vol. 32. 4 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Upcycling of POM for Catch Springs by Using the Rec2TecPart Process
Katschnig, M. & Holzer, C., 25 Jul 2016, The Digital Book of Abstracts. 32nd International Conference of the POLYMER PROCESSING SOCIETY, p. 287 S16-623Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
A New Device for Measuring Shear Viscosity of Rubbers on a Rubber Injection Molding Machine
Fasching, M., Friesenbichler, W., Leitner, E. & Berger, G., Jul 2016, p. 1-5. 5 p.Research output: Contribution to conference › Paper › peer-review
- Published
Characterization of the Temperature Profile during Dosing of Different Rubber Compounds under Steady State Conditions by Means of a Specially Designed Screw Test Stand
Kerschbaumer, R., Lechner, B., Graninger, G. & Friesenbichler, W., Jul 2016, p. 1-5. 5 p.Research output: Contribution to conference › Paper › peer-review
- Published
Influence of Processing Conditions and Filler Type and on the Crystallinity of PLA Compounds
Pacher, G., Hutterer, T., Berger, G. & Friesenbichler, W., Jul 2016, p. 1-5. 5 p.Research output: Contribution to conference › Paper › peer-review
- Published
Thermo-mechanical fatigue influence of copper and silicon on hypo-eutectic Al–Si–Cu and Al–Si–Mg cast alloys used in cylinder heads
Huter, P., Oberfrank, S., Grün, F. & Stauder, B., Jul 2016, In: International Journal of Fatigue. 88, p. 144-155Research output: Contribution to journal › Article › Research › peer-review
- Published
Fatigue Strength of a Multiaxial Loaded Short Glass Fibre Reinforced Polyamide
Primetzhofer, A., Mösenbacher, A. & Pinter, G., 30 Jun 2016. 8 p.Research output: Contribution to conference › Paper
- Published
On a Coupled Elasto-Plastic Damage Model for Fiber Reinforced Laminates
Gaddikere Nagaraja, S. & Schuecker, C., 30 Jun 2016.Research output: Contribution to conference › Abstract › peer-review
