Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
Publications / Theses
- 2016
- Published
Measurements of viscoelasticity and adhesion force of polymer materials with large radius AFM tips
Ganser, C., Czibula, C., Manhart, J., Radl, S., Schlögl, S., Hirn, U. & Teichert, C., 28 Sept 2016.Research output: Contribution to conference › Presentation › Research
- Published
Bonding forces in Fused Filament Fabricaiton
Spörk, M., 23 Sept 2016.Research output: Contribution to conference › Presentation › Research
- Published
Bonding Forces in Fused Filament Fabrication
Spörk, M., Schuschnigg, S., Holzer, C., Arbeiter, F. & Berger, G., 23 Sept 2016.Research output: Contribution to conference › Abstract › peer-review
- Published
Influence of mold steel on injection molding process: Experimental and numerical studies
Lucyshyn, T., 23 Sept 2016.Research output: Contribution to conference › Presentation › Research
- Published
Injection Molds - The Key to Quality Products
Holzer, C. & Lucyshyn, T., 23 Sept 2016.Research output: Contribution to conference › Abstract
- Published
On the Use of Bionic Cooling Structures in Injection Molding
Berger, G., Zorn, D., Bodor, C., Friesenbichler, W. & Bevc, F., 22 Sept 2016, p. 155-161. 7 p.Research output: Contribution to conference › Presentation › Research › peer-review
- Published
On the Use of Bionic Cooling Structures in Injection Molding
Berger, G., Zorn, D., Bodor, C., Friesenbichler, W. & Bevc, F., 22 Sept 2016, p. 155-161. 7 p.Research output: Contribution to conference › Paper › peer-review
- Published
On the Use of Bionic Cooling Structures in Injection Molding
Berger, G., Zorn, D., Bodor, C., Friesenbichler, W. & Bevc, F., 22 Sept 2016, Conference Proceedings: 7th bi-annual International Conference of Polymers & Moulds Innovations. Gent, p. 155-161 7 p. 21Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Simulation of Rubber Injection Molding - Challenges and Limitations
Friesenbichler, W., Berger, G. & Fasching, M., 22 Sept 2016, p. 179-183. 4 p.Research output: Contribution to conference › Paper › peer-review
- Published
Simulation of Rubber Injection Molding - Challenges and Limitations
Friesenbichler, W., Berger, G. & Fasching, M., 22 Sept 2016, p. 179-183. 4 p.Research output: Contribution to conference › Presentation › Research › peer-review
