Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
Publications / Theses
- 2009
- Published
New Rheological Injection Mould to Measure Pressure Dependent Viscosity in High Shear Rate Range
Friesenbichler, W., Rajganesh Jegadeesan, X., Duretek, I. & Ramesh Kumar, S., 2009,PPS-25 Program & Abstracts
. p. 185-185Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Novel thermoplastic silicone elastomers as gelling agent for silicone fluids
Rieß, G. & Schmidt, H-W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Numerical simulation of the failure behavior of PE pressure pipes with additional loads
Hutar, P., Sevcik, M., Nahlik, L., Mitev, I., Frank, A. & Pinter, G., 2009, ANTEC 2009 Society of Plastics Engineers' Annual Technical Conference. p. 2163-2168Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Numerical simulation of the failure behavior of PE pressure pipes with additional loads
Hutar, P., Sevcik, M., Nahlik, L., Mitev, I., Frank, A. & Pinter, G., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Oberflächenmodifizierung von PMMA zur Reduktion der Gleitreibung
Buchner, A., 2009Research output: Thesis › Master's Thesis
- Published
On the evaluation of the visual impact of sink marks of injection molded parts
Pacher, G. A., 2009Research output: Thesis › Master's Thesis
- Published
Optical structures in photosensitive polymers using the photo-decarbonylation of aromatic tertiary formamides
Edler, M., Haba, D., Belzik, M., Kern, W., Grießer, T., Trimmel, G. & Wolfberger, A., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Optimierung des Messaufbaus einer neuartigen Methode zur visuellen Charakterisierung des Erscheinungsbildes von Kunststoffoberflächen
Baumann, A., 2009, 100 p.Research output: Thesis › Master's Thesis
- Published
Patterned Photosensitive Ultrathin Films: combining Friction Force Microscopy and Contact Angle Measurements
Shen, Q., Hlawacek, G., Gürkan, N., Teichert, C., Lex, A., Trimmel, G. & Kern, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Phase separated thermotropic layers based on UV cured acrylate resins – Effect of material formulation on overheating protection properties and application in a solar collector
Resch, K., Wallner, G. & Hausner, R., 2009, In: Solar energy. p. 1689-1697Research output: Contribution to journal › Article › Research › peer-review
