Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
241 - 250 out of 3,454Page size: 10
Publications / Theses
- 2019
- Published
Bestimmung der thermodynamischen, rheologischen und mechanischen Stoffdaten eines Cyclic Block Copolymer
Duretek, I., 11 Sept 2019, 15 p.Research output: Book/Report › Commissioned report › Research
- Published
Investigation of the Applicability of Neogene Sediments as Fillers for Polymeric Materials
Wegerer, E. & Aust, N., 11 Sept 2019.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Fused filament fabrication, debinding and sintering as a low cost additive manufacturing method of 316L stainless steel
Thompson, Y., Gonzalez-Gutierrez, J., Kukla, C. & Felfer, P., 9 Sept 2019, In: Additive Manufacturing. 30.2019, December, 8 p., 100861.Research output: Contribution to journal › Article › Research › peer-review
- Published
Influencing carbonate scaling by tailored drainage materials in tunnels - an experimental approach
Eichinger, S., Arbeiter, F., Boch, R., Schachinger, T. & Dietzel, M., 6 Sept 2019.Research output: Contribution to conference › Poster › Research
- Published
Finite Element Models Describing the Failure in Steel Cable Reinforced Rubber Composites
Frankl, S. M., 3 Sept 2019.Research output: Contribution to conference › Abstract
- Published
Fretting behavior of thermoplastic polyurethanes
Wang, C., Hausberger, A., Berer, M., Pinter, G., Grün, F. & Schwarz, T., 1 Sept 2019, In: Lubricants. 7, 9, 73.Research output: Contribution to journal › Article › Research › peer-review
- Published
Physical foaming and crosslinking of polyethylene with modified talcum
Kaltenegger-Uray, A., Rieß, G., Lucyshyn, T., Holzer, C. & Kern, W., 1 Sept 2019, In: Polymers. 11, 9, 1472.Research output: Contribution to journal › Article › Research › peer-review
- Published
NOVEL APPROACHES FOR LIFETIME PREDICTION OF COMPOSITE MATERIALS FOR STRUCTURAL APPLICATIONS UNDER STATIC LOADS
Pilz, G., Gloggnitzer, S., Schneider, C. & Pinter, G. G., Sept 2019.Research output: Contribution to conference › Paper › peer-review
- E-pub ahead of print
Impact Optimization of 3D‐Printed Poly(methyl methacrylate) for Cranial Implants
Petersmann, S., Spoerk, M., Huber, P., Lang, M., Pinter, G. & Arbeiter, F., 30 Aug 2019, (E-pub ahead of print) In: Macromolecular materials and engineering. 304.2019, 11, 10 p., 1900263.Research output: Contribution to journal › Article › Research › peer-review
- Published
Finite element model to describe crack deflection and constrained micro-cracking
Tauscher, M., Pletz, M., Arbeiter, F. & Schuecker, C., 28 Aug 2019, p. 371-374. 4 p.Research output: Contribution to conference › Paper
