Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
Publications / Theses
- 2010
- Published
Kunststoffverarbeitung - über Spritzguß und Extrusion hinaus
Holzer, C., 2010, In: KC-aktuell (Informationen aus dem Kunstoff-Cluster). p. 1-3Research output: Contribution to journal › Article › Research › peer-review
- Published
Making of Low Allergenic Surgical Gloves from Natural Rubber Latex via UV Techniques
Schloegl, S., Schaller, R., Holzner, A. & Kern, W., 2010, Book of Abstracts. p. 82-82Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Manufacture of Non-Allergenic Surgical Gloves via UV Techniques
Schlögl, S., Temel, A., Kern, W., Schaller, R. & Holzner, A., 2010, In: Kautschuk, Gummi, Kunststoffe. 63, 5, p. 187-191Research output: Contribution to journal › Article › Research › peer-review
- Published
Mathematical Modeling and Optimization of Run Parameters of Crystallization Analysis Fractionation (CRYSTAF)
Fischlschweiger, M., Aust, N., Oberaigner, E. & Kock, C., 2010, In: Macromolecular chemistry and physics. 211, p. 383-392Research output: Contribution to journal › Article › Research › peer-review
- Published
Mathematical modelling of the flow behaviour in the pressure build-up zone of a conical co-rotating twin screw extruder
Selvasankar, R. K., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Measurement of pressure dependent viscosity and its influence on injection molding simulation
Friesenbichler, W., Rajganesh Jegadeesan, X., Lucyshyn, T., Filz, P. & Webelhaus, K., 2010, 4th International PMI Conference - Conference Proceedings. p. 215-219Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Mechanische Charakterisierung eines glasfaserverstärkten UP-Werkstoffes
Guttmann, P. & Pinter, G., 2010Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Mechanische Leistungssteigerung von Butadienkautschuken durch Modifizierung mit Carbon-Nanotubes
Mach, E. R., 2010Research output: Thesis › Master's Thesis
- Published
Mechanische und morphologische Untersuchungen an Polyolefin/Algen-Compounds
Feuchter, M. & Pinter, G., 2010Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Method development for the reliability testing of printed circuit boards under dynamic loads
Major, Z. & Fuchs, P. F., 2010.Research output: Contribution to conference › Poster › Research › peer-review
