Department Materials Science
Organisational unit: Departments & Institutes
3491 - 3500 out of 4,591Page size: 10
Publications / Theses
- 2007
- Published
Ortsabhängige Charakterisierung von mechanischen und elektrischen Kenngrößen von Varistoren
Frey, S., 2007Research output: Thesis › Diploma Thesis
- Published
Oxidation of arc evaporated Al1-xCrxN coatings
Reiter, A., Mitterer, C. & Sartory, B., 2007, In: Journal of vacuum science & technology / A (JVST). A 25, p. 711-720Research output: Contribution to journal › Article › Research › peer-review
- Published
Oxidation of vanadium nitride and titanium nitride coatings
Glaser, A., Surnev, S., Netzer, F. P., Fateh, N., Fontalvo, G. & Mitterer, C., 2007, In: Surface Science. 601, p. 1153-1159Research output: Contribution to journal › Article › Research › peer-review
- Published
Oxidation Tuning of Cr-Al-N by yttrium
Rovere, F., Mayrhofer, P. H. & Braun, R., 2007.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Oxidation Tuning of Cr-Al-N by yttrium
Rovere, F. & Mayrhofer, P. H., 2007.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Oxide-based Coatings Deposited by Thermal CVD
Czettl, C., 2007, 82 p.Research output: Thesis › Diploma Thesis
- Published
Phase Transitions and Recrystallization in a Ti-46at%Al-9at%Nb Alloy as Observed by In-Situ High-energy X-ray Diffraction
Liss, K-D., Clemens, H., Bartels, A., Stark, A. & Buslaps, T., 2007, MRS Fall Meeting. Materials Research Society : MRS, p. II05-07-II05-13Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
PM mit HM-ähnlichen Eigenschaften bzw. Werkzeugstähle mit höchster Festigkeit und Zähigkeit
Zuber, M. & Leitner, H., 2007Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Pore lattice deformation in ordered mesoporous silica studied by in-situ small-angle X-ray diffraction
Zickler, G., Jähnert, S., Funari, S. S., Findenegg, G. H. & Paris, O., 2007, In: Journal of applied crystallography. 40, p. s522-s526Research output: Contribution to journal › Article › Research › peer-review
- Published
Použití centrálně zatězované desky na třech podporách k určení pevnosti křehkých materiálů
Chlup, Z., Kozák, V. & Supancic, P., 2007, Křehký lom 2007 - Porušování a design materiálů. p. 196-208Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
