Chair of Materials Science and Testing of Polymers (210)
Organisational unit: Chair
211 - 220 out of 1,415Page size: 10
Publications / Theses
- 2018
- Published
Fracture mechanical approach to identify the behavior of elastomers in hostile environments
Balasooriya, W., Schrittesser, B., Pinter, G. G. & Schwarz, T., 2018.Research output: Contribution to conference › Poster › Research
- Published
Fracture mechanical characterization of non-virgin pipe materials
Frank, A., Berger, I. J., Koch, T., Arbeiter, F. & Pinter, G. G., 2018, Proceedings ANTEC 2018.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
High Performance Composites Produced from Polyfurfuryl Alcohol: Enhancing the Process Ability at Short Cycle Times by Applying Hydrophilic Reinforcement
Resch-Fauster, K., Dzalto, J., Anusic, A. & Mitschang, P., 2018, Proceedings of ECCM18 - 18th European Conference on Composite Materials.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Impact of polyolefin impurities on lifetime relevant properties of polyethylene and polypropylene
Messiha, M., 2018Research output: Thesis › Master's Thesis
- Published
Influence of backsheet-encapsulant combinations on PV degradation modes
Castillon, L., Oreski, G. & Pinter, G. G., 2018.Research output: Contribution to conference › Poster › Research
- Published
INFLUENCE OF CONDITIONING TIME AND WET CHEMICAL SURFACE TREATMENT ON AIRCRAFT REPAIR
Röper, F., Wolfahrt, M., Kucher, G., Bubestinger, A. & Pinter, G. G., 2018, Proceedings ECCM 18.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of curing degree on the mechanical performance of polymer matrix composites
Wolfahrt, M., Pilz, G. & Lang, R., 2018.Research output: Contribution to conference › Paper › peer-review
- Published
InSitu tribological and fracture mechanical investigation of Thermoplastic Polyurethanes
Stiller, T., 2018Research output: Thesis › Master's Thesis
- Published
Investigation of the Failure Behavior of Polyethylene Electrofusion Sockets
Berger, I. J., Frank, A., Pinter, G. G., Nitsche, D. & Petry, D., 2018, Proceedings Plastics Pipes XIX.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Material Development and Modelling of a Thermal Insulation Film in Battery Systems
Petersmann, S., 2018Research output: Thesis › Master's Thesis
