Chair of Materials Science and Testing of Polymers (210)
Organisational unit: Chair
Publications / Theses
- 2018
- Published
Effect of the water absorptive capacity of reinforcing fibers on the process ability, morphology, and performance characteristics of composites produced from polyfurfuryl alcohol
Resch-Fauster, K., Dzalto, J., Anusic, A. & Mitschang, P., 12 Feb 2018, In: Advanced Manufacturing: Polymer and Composites Science. 4.2018, 1, p. 13-23 11 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Fracture mechanical characterization and lifetime estimation of near-homogeneous components produced by fused filament fabrication
Arbeiter, F., Spoerk, M., Wiener, J., Gosch, A. & Pinter, G., 5 Jan 2018, In: Polymer Testing. 66.2018, April, p. 105-113 9 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of crosslinker and water on mechanical properties of carboxylated nitrile butadiene rubber (XNBR)
Fleischmann, D. D., Ayalur-Karunakaran, S., Arbeiter, F., Schaller, R., Holzner, A., Kern, W. & Schlögl, S., 5 Jan 2018, In: Polymer Testing. 66.2018, April, p. 24-31 8 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Aging Mechanism of Polyethylene Pipe Material in Chlorine Dioxide and Hypochlorite Solution
Bredács, M., Frank, A., Bastero, A., Stolarz, A. & Pinter, G. G., 2018, Proceedings Plastics Pipes XIX. 11 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Analysis and Development of Transport Phenomena Models for PV Modules
Castillon, L., Oreski, G. & Pinter, G. G., 2018.Research output: Contribution to conference › Poster › Research
- Published
A STRENGTH BASED APPROACH ON S-N CURVES FOR THE FATIGUE LIFE ASSESSMENT OF CONTINUOUSLY FIBER REINFORCED COMPOSITES
Pinter, G. G., Gaier, C., Maier, J., Fischmeister, S. & Dannbauer, H., 2018, Proceedings ICFC7. 4 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Biomimetic Design Concepts for the Pipe Architecture of Tomorrow
Pinter, G. G., Arbeiter, F., Wiener, J., Frank, A. & Kolednik, O., 2018, Proceedings Plastics Pipes XIX. 8 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Characterisation of degradation behaviour and material interactions in PV modules
Barretta, C., Oreski, G., Resch-Fauster, K. & Pinter, G. G., 2018.Research output: Contribution to conference › Poster › Research
- Published
Characterization and modeling of the cure-induced shrinkage of an epoxy resin used in organic laminate based electronic modules
Zündel, J. V., 2018Research output: Thesis › Master's Thesis
- Published
Comparison of real and simulated failure times based on the slow crack growth behavior
Berger, I. J., Frank, A., Pinter, G. G., Nitsche, D. & Petry, D., 2018, Proceedings ANTEC 2018. 6 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
