Florian Müller
(Former)
21 - 25 out of 25Page size: 10
Publications / Theses
- 2012
- Published
Runner balancing in multi-cavity injection molds by time controlled valve gates
Lucyshyn, T., Müller, F., Doppelmayer, N., Rath, G., Kukla, C. & Holzer, C., 2012, Proceedings of the Polymer Processing Society 28th Annual Meeting ~ PPS-28. p. xxx-xxxResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Runner balancing in multi-cavity injection molds by time controlled valve gates
Lucyshyn, T., Müller, F., Doppelmayer, N., Rath, G., Kukla, C. & Holzer, C., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Wireless In-Mold Sensor for Injection Molding: A new Approach
Müller, F., Kukla, C., Lucyshyn, T. & Holzer, C., 2012, Proceedings of the Polymer Processing Society 28th Annual Meeting ~ PPS-28. p. XXX-XXXResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- 2011
- Published
Influence of the heat transfer coefficient on the injection molding simulation of microstructures
Müller, F., Lucyshyn, T., Kukla, C. & Holzer, C., 2011, Conference Proceedings - ICIT & MPT 2011 . p. 141-148Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- 2010
- Published
Experimentelle und numerische Untersuchungen des Einflusses von Spritzgieß-Parametern auf Bauteildimensionen unter Verwendung von zwei unterschiedlichen optischen Messsystemen
Müller, F., 2010Research output: Thesis › Master's Thesis
