Department Polymer Engineering and Science
Organisational unit: Departments & Institutes
771 - 780 out of 3,454Page size: 10
Publications / Theses
- 2017
- Published
Comparison of real and simulated failure times of electrofusion sockets made of polyethylene
Frank, A., Berger, I. J., Pinter, G. G., Nitsche, D. & Petry, D., 2017, In: Joining plastics = Fügen von Kunststoffen. 11, 3/4, p. 158 164 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Concept of Optimized Encapsulant Composition for PV Module Reliability under Different Climatic Conditions
Mihaljevic, A., Oreski, G., Eder, G. C., Voronko, Y., Mühleisen, W., Neumaier, L., Hirschl, C., Ebner, R. & Pinter, G. G., 2017.Research output: Contribution to conference › Poster › Research
- Published
Delamination properties of hybrid steel- carbon composite materials produced via resin transfer molding
Stelzer, S., Brandstetter, D., Hergan, P., Fauster, E. & Pinter, G. G., 2017.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Design and manufacturing of high performance green composites based on renewable materials
Resch-Fauster, K., Klein, A., Lloret Pertegas, S. & Schledjewski, R., 2017, Handbook of Composites from Renewable Materials, Vol. 2, Design and Manufacturing. Wiley-VCH , p. 1-24Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Design of Experiments Versuche an Hybridplatten – Betrachtung der Phänomene des RTM-Prozesses
Beter, J., 2017Research output: Thesis › Master's Thesis
- Published
- Published
Determination of Thermal Conductivity of an Industrial Rubber Compound: Challenges, Problems and Comparison of Different Test Methods
Kerschbaumer, R., Lechner, B., Tscharnutter, D., Wanner, A. J. & Friesenbichler, W., 2017, Conference Proceedings of the RubberCon.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Document Simple method for the quantitative analysis of thin copolymer films on substrates by infrared spectroscopy using direct calibration
Tazreiter, M., Christian, P., Schennach, R., Grießer, T. & Coclite, A. M., 2017, In: Analytical Methods. 9, 5266Research output: Contribution to journal › Article › Research › peer-review
- Published
Effect of Particle Size on the Properties of Highly-Filled Polymers for Fused Filament Fabrication
Kukla, C., Gonzalez-Gutierrez, J., Duretek, I., Schuschnigg, S. & Holzer, C., 2017.Research output: Contribution to conference › Paper › peer-review
- Published
Efficient initiation of radical‐mediated thiol‐ene chemistry with photoactive silica particles
Sahin, M., Schlögl, S., Kaiser, S., Kern, W., Wang, J. & H., G., 2017, In: Journal of polymer science : A, Polymer chemistry. p. 894-902 55.Research output: Contribution to journal › Article › Research › peer-review
