Chair of Materials Science and Testing of Polymers (210)
Organisational unit: Chair
451 - 460 out of 1,415Page size: 10
Publications / Theses
- 2015
- Published
Mechanical and Thermal Characterisation of Epoxy Insulation with Inorganic Fillers
Pothukuchi, H. K. R., Fuchs, P. & Stelzer, S., 2015.Research output: Contribution to conference › Poster › Research
- Published
Method to characterize the damping behavior of thin passively constrained layer laminates using dynamic mechanical analysis (DMA) in shear mode
Knapp, G., Oreski, G. & Pinter, G., 2015, In: Polymer Testing. 42, p. 215 224 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
(Nano)Composite mit hoher Wärmeleitfähigkeit
Wanner, A. J., Moser, A., Feuchter, M. & Kern, W., 2015.Research output: Contribution to conference › Presentation › Research
- Published
Novel composite-composite joining technology with through thickness reinforcement for enhanced damage tolerance
Stelzer, S., Ucsnik, S. & Pinter, G., 2015.Research output: Contribution to conference › Presentation › Research
- Published
Point load effect on the buried polyolefin pipes lifetime
Hutař, P., Majer, Z., Frank, A., Sevcik, M., Zouhar, M., Pinter, G. & Náhlík, L., 2015, In: Polymer engineering and science.Research output: Contribution to journal › Article › Research › peer-review
- Published
POLYMER-PHYSICAL ANALYSIS OF UNUSUAL MORPHOLOGICAL EFFECTS IN NATURAL FIBRE COMPOSITES
Resch, K., Su, X., Gong, S. & Wool, R., 2015, Proceedings of 20th International Conference on Composite Materials.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Potential and properties of soft polymeric composites produced from renewable resources
Resch, K., Gong, S., Sauerbrunn, S. & Wool, R., 2015, Proceedings of Polymer Processing Society Conference (PPS) 2015, Graz, Austria.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Potentials and Limitations of Vibrational Spectroscopy for the Characterisation of Polymers
Bruckmoser, K., 2015Research output: Thesis › Doctoral Thesis
- Published
Restlebenszeitmodellierung von Polyethylen-Rohren auf Basis des Arrhenius-Konzepts
Kaufmann, M., 2015Research output: Thesis › Master's Thesis
- Published
Software-basierte Methode zur Lebensdauerabschätzung endlosfaserverstärkter Kunststoffe
Maier, J., Gaier, C., Stelzer, S. & Pinter, G., 2015.Research output: Contribution to conference › Presentation › Research
