Chair of Polymer Processing (350)

Organisational unit: Chair

731 - 740 out of 768Page size: 10

Publications / Theses

  1. 2006
  2. Published

    Simulation des Thermoformprozesses

    Fertschej, A., 2006, 19. Leobener Kunststoff Kolloquium - Spritzgieß- und Extrusionstechnik - Innovationen aus Industrie und Forschung. p. 1-15

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  3. Published

    Simulation und Einfluss des Kühlprozesses auf die Morphologie von PP-Rohren

    Nestelberger, S., 2006, 132 p.

    Research output: Thesis › Diploma Thesis

  4. Published

    Spritzgießsimulation - Einfluss der Stoffdaten auf die Vorhersage von Schwindung und Verzug

    Lucyshyn, T., Duretek, I., Fischer, K. & Langecker, G., 2006, 19. Leobener Kunststoff Kolloquium - Spritzgieß- und Extrusionstechnik - Innovationen aus Industrie und Forschung. p. 1-17

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  5. Published

    Stoffdaten für die Simulation

    Duretek, I., 2006.

    Research output: Contribution to conference › Poster › Research › peer-review

  6. Published

    Stoffdaten und Simulation

    Lucyshyn, T., 2006.

    Research output: Contribution to conference › Poster › Research › peer-review

  7. Published

    Study on rheological behaviour of polymer melts at high shear rates using a new micro-rheology technique

    Duretek, I., Friesenbichler, W., Schuschnigg, S., Jegadeesan, R. & Langecker, G., 2006, Past and future of polymer engineering technology and science. p. 117-130

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  8. Published

    Study on rheological behaviour of polymer melts at increased pressure levels with the consideration of the compression heat

    Rajganesh Jegadeesan, X., Friesenbichler, W., Duretek, I., Schuschnigg, S. & Langecker, G., 2006, The Chain of Knowledge - From Catalyst to Application. p. 1-1

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  9. Published

    Untersuchungen zur Abformung geometrischer und stochastischer Strukturen an Spritzgießformteilen

    Berger, G., 2006

    Research output: Thesis › Doctoral Thesis

  10. Published

    Ursache von Tigerstreifen auf Spritzgussteilen und deren Vorhersage mittels Spritzgieß-Simulation

    Gsellmann, G. F., 2006, 115 p.

    Research output: Thesis › Diploma Thesis

  11. Published

    Viscoelastic properties of unreinforced and reinforced plastic lumber

    Stadler, M. A., 2006

    Research output: Thesis › Diploma Thesis

Previous 1...70 71 72 73 74 75 76 77 Next
View graph of relations

Contact information

Otto Glöckel-Straße 2/III, 8700 Leoben
  • Main phone number: +43 3842 402 3501