International Journal of Fatigue, ‎0142-1123

Journal

ISSNs0142-1123
1 - 10 out of 46Page size: 10

Publications / Theses

  1. Published

    Dynamic mechanical response of polyetheretherketone (PEEK) exposed to cyclic loads in the high stress tensile regime

    Berer, M., Tscharnuter, D. & Pinter, G., 2015, In: International Journal of Fatigue. 80, p. 397-405

    Research output: Contribution to journal › Article › Research › peer-review

  2. Published

    Mechanical properties, fatigue damage and microstructure of carbon/epoxy laminates depending on fibre volume content

    Brunbauer, J., Pinter, G. & Stadler, H., 2014, In: International Journal of Fatigue. 70, p. 85-92

    Research output: Contribution to journal › Article › Research › peer-review

  3. Published

    Mode II fatigue delamination resistance of advanced fiber-reinforced polymer–matrix laminates: Towards the development of a standardized test procedure

    Brunner, A., Stelzer, S., Pinter, G. & Terrasi, G. P., 2013, In: International Journal of Fatigue. 50, p. 57-62

    Research output: Contribution to journal › Article › Research › peer-review

  4. Published

    Cyclic fatigue delamination of carbon fiber-reinforced polymer-matrix composites: Data analysis and design considerations

    Brunner, A., Stelzer, S., Pinter, G. & Terrasi, G. P., Feb 2016, In: International Journal of Fatigue. 83, p. 293-299 7 p.

    Research output: Contribution to journal › Article › Research › peer-review

  5. Published

    Application of modified Kitagawa-Takahashi diagram for fatigue strength assessment of cast Al-Si-Cu alloys

    Garb, C., Leitner, M., Stauder, B., Schnubel, D. & Grün, F., 1 Jun 2018, In: International Journal of Fatigue. 111, p. 256-268 13 p.

    Research output: Contribution to journal › Article › Research › peer-review

  6. E-pub ahead of print

    Mixed Mode I/III fatigue fracture characterization of Polyoxymethylene

    Gosch, A., Berer, M., Hutař, P., Slavik, O., Vojtek, T., Arbeiter, F. & Pinter, G. G., 13 Sept 2019, (E-pub ahead of print) In: International Journal of Fatigue. 130.2020, January, p. 105269 11 p.

    Research output: Contribution to journal › Article › Research › peer-review

  7. Published

    Fatigue characterization of polyethylene under mixed mode I/III conditions

    Gosch, A., Arbeiter, F., Berer, M., Vojtek, T., Hutař, P. & Pinter, G. G., 15 Dec 2020, In: International Journal of Fatigue. 145.2021, April, 13 p., 106084.

    Research output: Contribution to journal › Article › Research › peer-review

  8. Published

    A novel high-frequency fatigue testing methodology for small thin-walled structures in the HCF/VHCF regime

    Himmelbauer, F., Tillmanns, M., Winter, G., Gruen, F. & Kiesling, C., 19 Jan 2021, In: International Journal of Fatigue. 146.2021, May, 10 p., 106146.

    Research output: Contribution to journal › Article › Research › peer-review

  9. Published

    High- and low-cycle fatigue influence of silicon, copper, strontium and iron on hypo-eutectic Al–Si–Cu and Al–Si–Mg cast alloys used in cylinder heads

    Huter, P., Renhart, P., Oberfrank, S., Schwab, M., Grün, F. & Stauder, B., 1 Jan 2016, In: International Journal of Fatigue. 82, 3, p. 588–601

    Research output: Contribution to journal › Article › Research › peer-review

  10. Published

    Thermo-mechanical fatigue influence of copper and silicon on hypo-eutectic Al–Si–Cu and Al–Si–Mg cast alloys used in cylinder heads

    Huter, P., Oberfrank, S., Grün, F. & Stauder, B., Jul 2016, In: International Journal of Fatigue. 88, p. 144-155

    Research output: Contribution to journal › Article › Research › peer-review

Previous 1 2 3 4 5 Next
View graph of relations